DIY Christmas Mesh Wreath

DIY Christmas Mesh Wreath

This week we are getting ready for Christmas with everyone's favorite Christmas villain! Our floral designer Tim used a variety of florals, ribbon and mesh to create this fun & festive wreath. This wreath is sure to put friends & family in the festive Holiday spirit! You can create one of your very own using the steps and supplies listed below

Supplies needed: 

• (1) 24" Scotch Pine Wreath
• (1) 10" Metallic Deco Mesh - Lime Green
• (1) 24" Grinch Monster Head Pick 
• (2) 27" Glittered Red Berries & Lime Green Leaves Floral Spray
• (2)12" Red & Lime Green Tubing and Snowdrift Ball Pick 
• (2) 28" Furry Lime Green Curly Spray
• (1) 1.5" Lime Green Velvet Tinsel Edge Ribbon
• (1) 4" Lime Green Velvet Ribbon with Tinsel Trim
• (1) 2.5" Red Brick with Monster Hand Christmas Ribbon
• (2) 100MM Red Chunky Glitter Ball Ornament
• Hot Glue
• Wire Cutters
• Scissors
• Floral Wire

• First things first, before getting started make sure you have gathered all of the necessary supplies

• To get started, Tim began adding the 10" Lime Green Deco Mesh to the Evergreen Wreath. He used the branches of the wreath to tie the Mesh and created loops around the wreath. He worked his way around the Wreath until the surface was covered with Mesh.

• Next he attached the 24" Grinch Head to the left hand side of the wreath using hot glue and floral wire. He poked a hole through the back of the plush head to then be able to wire it to the wreath. 

• Once the Grinch was on the wreath Tim  worked on adding the ribbon. He looped the three different ribbons in between the loops of Mesh. He started just below the Grinch head and finished just above it. 

• Next Tim tied a large 4 loop bow using the same 3 ribbons and attached it to the right hand side of the wreath. He left the tails long on this bow to hang down the front of the wreath. 

• Tim then worked on adding the florals and accents to the wreath. He added one of the loopy ball picks to the top and bottom of the Wreath. 

• Then he also added one of the Glittery Berry Sprays to the top and bottom of the wreath. 

• He added the 100mm Glitter Ball Ornaments throughout the Wreath also.

• Finally, Tim added the Fuzzy Curly Sprays to the wreath to finish it off. He added one to the top of the wreath and then one at the bottom under the bow.

• When you have finished adding all of your components you can come to a stopping point. You will have a fun & festive Wreath to use throughout the Holiday season.

← Previous Post Next Post →